1
...the auditorium itself to construct an acoustic enclosure. Milbury will also supply the concrete for the Chorus and Auditorium seating areas. “The walls were originally designed as blockwork”, explained Koshe Patel, business development manager at Milbury Systems. “However, there was a concern regarding the number of mortar joints that occur with blockwork. See #2.
LCS
...this building on two occasions most recently during the construction of a 2, 000 square metre extension to the store. All units were hand cast including ‘semi-dry’ ashlar blockwork, polished lintels and wet cast cornice. Mixes were specifically designed to ensure that wet and semi-dry cast components complemented each other. LCS produced... See #3.
Advantages of Concree
...Reduction The acoustic performance of the True-Crete refuse chute with its smooth interior and 75mm concrete wall is unmatched. Decoration No need for any cladding, i.e. Brickwork, Blockwork or Partition walls. Fire Resistance Our concrete units have been successfully tested for 4 hours. Long-Lasting True-Crete's refuse chutes are made to last... See #4.
Brikmat Masonry Support Systems Testing
...if any, the inclusion of Brikmat would have on a masonry construction. The BBA commented: "The incorporation of the product into the horizontal mortar joints of brickwork and blockwork will have no adverse effect on the compressive, flexural or shear properties of the wall". Section 7: General: "Use of the product will provide... See #5.
Bison Precast Concrete: Innovation: Lifting Hooks
...on site; Much greater speed of erection (upwards of 50% having been achieved on certain projects); Minimisation of damage to soffit of product; Significantly reduced damage to blockwork bearings during erection. The Technology behind the product Bison Concrete Products Ltd sourced a method of automatic insertion of lifting hooks that could... See #6.
Nufins Products - concrete formwork treatments, release agents, resin mortar, paving...
This may material can be applied with the use of a pump Uniseal 120 A one-part polysulphide sealant complying to ISO 11600 20HM. For perimeter pointing around timber, brick and blockwork. Uniseal 140 A one-part low modulus sealant which cures on exposure to air to give a very elastic silicone rubber seal Uniseal 150 A one-part gun applied... See #7.
Robeslee Concrete - Prestressed & Precast Concrete. Kirkintilloch, Scotland.
It is essential that the first two layers of brickwork, or one layer of blockwork, are laid with special care and that the mortar joints both vertical and horizontal are properly filled, leaving no voids. (1:3 cement, sand mortar is recommended). Building blocks may be used if they are solid and have a minimum crushing streanth of 3. See #8.
Cafco International - Construction Industry Topcoats and Sealers
Because of its water vapour permeability, Topcoat 200 does not blister when used on these substrates. Topcoat 200 may also be used on masonry, brickwork and blockwork, whether dry or damp. Topcoat 200 protects against ingress from salt spray, washdown water, chemical spills, rainfall and sprinkler deluge systems. It is... See #9.
www.alderburgh.com
Alderprufe MR50 Alderprufe MR50 self adhesive waterproofing gas resistant membrane is intended for use in concrete, brickwork and blockwork construction, both internally and externally, to protect buildings against water and the ingress of methane, carbon dioxide and radon gases from the ground. Alderprufe MR50 high... See #10.
Advanced Hygienic Contracting Limited UK: Decorative bathroom and kitchen wall cladding
Single skin pastel range This is a single skin 2.5mm thick selfcoloured PVC. Bonded and thermoformed onto flat dry surfaces such as tiles, blockwork and drylining to give an impact resistant, maintenance free decorative finish. Available Colours Matching pastel colour trims available throughout the range. See #11.
Fermacell high performance multi-purpose dry lining board
Fermacell, Xella, dry lining, drylining, dry-lining, acoustic, part e, board, walls, ceilings floors, wall board, high performance, gypsum board, partition, blockwork, uk, installation, install, tapered edge, FST, handy board, drywall, construction, HD exterior board, Protektor. See #12.
Oak Beams
...1"-2" thick, they are fixed to the face of the wall, and plastered in between, as shown in the adjacent photograph. These are an ideal way of adding character to plain blockwork walls. Click Here to email us with questions or comments about this web site. See #13.
Nu-Sil, Nucoat Products Paint, Intumescent Varnish, Class 0 Paint, Intumescent Coatings and...
...effectively removed using our Graffiti Remover. General stains can be easily removed by washing with Clear Protector, followed by clean water. Suitable for application to brick and blockwork. Site Map. See #14.
Roger Wilde Ltd UK - Glass Blocks, Glass Block Installation and Glass Blockwork
Roger Wilde LTD, is a leading uk specialist installer of high quality glass block-work and glass block installation. See #15.
| 
