Gyproc Drywall Timber Screws
...Drywall Timber Screws Corrosion resistant self-tapping zinc plated steel screws with countersunk cross-heads. Supplied with screwdriver bits. Ideal for fixing plasterboard to stud framing. The length of screw selected for a given boarding configuration should be sufficient to give a nominal 25mm penetration into timber framing. Sizes Length... See #2.
General Technical Information
...caused by temperature variations and seismic forces. The angle brackets, attachment clips, and wall runners facilitate simple installation to various substrates including steel stud framing, aluminum curtain wall frames, plywood, and gypsum sheathing or existing masonry walls and existing EIFS wall surfaces. In the case of interior paneling... See #3.
Vermont Timber Frames
...of the resistance to the passage of heat) and low U-Values (a coefficient of heat transfer). Foam construction eliminates the voids and thermal bridges common in conventional stud framing and Fiberglass insulation. In SIP construction the rigid insulation blankets the entire structure in a well-sealed envelope. Less air leakage means fewer... See #4.
Dog Kennel Run
...10x12 $2, 550 $2, 850 Addtional travel charges may apply Standard Features • 4” x 4” Pressure Treated Timber Base • 2” x 4” Kiln Dried Wall Stud Framing, ( 24” on center) • 2” x 4” Roof Trusses, ( 24” on center) • 1” x 6” Texture 1-11 Siding or Pine Shiplap... See #5.
Architect Data 2
All work shall be done in a workmanlike manner, conforming to industry standards, including but not limited to the following: 1. Wall and ceiling panel and related steel stud framing and/or wood furring 2. Multi-purpose CRS Convert-A-Court Moving Glass Backwall 3. Light fixtures 4. CRS Glass walls (with Opacified Glass Design optional) 5. See #6.
Light Guage Steel FAQs
Steel strapping, installed horizontally on the interior flanges at a maximum of six (6) feet on center, in conjunction with the sheathing will brace and protect the stud framing during construction. If mechanical bracing is required it can be either steel strapping run horizontally on both sides of the studs and attached to each... See #7.
| 
