Cypher Ltd: Environmental Solutions, Road building, road dust control, soil stabilization in...
...part of the world in answering one of mankind¹s basic needs, namely economical and durable shelter. EarthZyme ® is used primarily to create a super-strong, super-bonded road surface that is impervious to moisture, moisture being a leading cause of road erosion and deterioration. The catalytic reaction of the enzyme in road-building... See #2.
Gritting and Snow Clearance
...Questions Gritting and Snow Clearance The decision to grit roads is based on 4 weather forecasts received each 24 hours from the met office. These forecasts give the anticipated road surface temperature and the predicted weather forecast for the night ahead. If the forecast anticipates conditions that require gritting to take place, then the... See #3.
Installing Rediweld Sitecop - traffic calming, traffic management and site safety
...and Setting Out Ensure that no drains, hydrants or service outlets will be covered. Work out gap width between kerb and the end cap. Advised width is 200mm. Mark out in chalk on road surface, the edge line. Position the end cap from the edge line and lay out the scaffold pole (not provided by Rediweld) with 45mm of its end under the end cap. See #4.
Pendulum Test for FibreGrid's slip resistant safety products
The Skid Resistance Tester operates thanks to a pendulum with a rubber slider, which bounces from a fixed height and sharpens with an edge over a fixed length of the road surface. The energy converted by the sliding procedure is determined on the basis of the climbing height of the pendulum and results in a measure for the pavement... See #5.
Hazard Safety - SpeedStopper PLUS
The various profile designs will control traffic speed to 5mph, 10mph or 15mph. Drivers intuitively see the bolt down speed ramp as a foreign object on the road surface and drive over at a safe and low speed. The self-coloured black rubber is contrasted with two bright yellow stripes and end caps, the correct hazard warning colours. See #6.
PWS - Portable, Variable and Changeable Message Signs and Arrowboards
It transmits a low-power microwave signal of constantly varying frequency in a fixed fan-shaped beam. The beam "paints" a long elliptical footprint on the road surface. Any non-background targets will reflect the signal back to the RTMS where the targets are detected and their range measured. The RTMS range measurement... See #7.
Brett - Glossary
Coated macadam This is a material made of graded aggregate, coated with bitumen. The interlocked aggregate particles are responsible for the compacted road surface?s strength. Because strength of macadam is derived from mechanical interlock, crushed rock is the normal choice of aggregate Concrete aggregate Aggregate... See #8.
NSS Group PLC
CONTRACTS DEESIDE ROAD CROSSING UK NSS installed an aluminium rig on tracks on the main Deeside bridge road surface with a section suspended over the parapet. The system was cantilevered 3m on the underside of the bridge to carry a half tonne test weight. -----------------------------------------------------------... See #9.
| 
