SCHUNDLER COMPANY-Transit Mix Perlite Concrete
...excess water bleeds out without loss of cement. Wet Density The wet density of perlite insulating concrete as poured is important in the control of the physical properties of the dry concrete and the yield achieved. The strength and the insulating value depend on the wet density. Heavier weight means greater strength and less insulation. Therefore, ... See #2.
C-Cure - Prep Products
...all types of tile, marble and stone over a variety of surfaces. UltraCure 971 is trowel applied to develop a continuous positive moisture barrier with excellent adhesion to wood, dry concrete slabs, steel, plastic laminate countertops, concrete block and cementitious backer units. This product is covered by a 5 Year Warranty and a 10 Year Warranty. See #3.
Selected Product Guide
...regulations and meets the requirements of NCHRP Report 244 and SS W110C specifications. Fluid Applied Flooring 09670 Aquaseal High-build protective coating for underwater, damp or dry concrete surfaces. It is a two component 100% solids, highstrength, high modulus epoxy. 09670 Duraltex 1705 A high build epoxy floor surface. It may be used as... See #4.
Edge Diamond Blades at EdgeDiamond.com - home of the industry's best diamond cores and...
...blade, asphalt diamond blade, dry wet tile blade, dry cut diamond blade, saw blade, wet cut diamond saw blade, wet cut cured diamond saw blade, diamond products, wet concrete blade, dry concrete blade, masonry diamond blade, core drilling equipment, diamond core bit, custom core bit, wet refractory diamond blade, random crack diamond saw blade, asphalt... See #5.
Pine Hall Brick - Do It Yourself
For finer cuts, a brick splitter or a power saw with a masonry blade can be rented from a local equipment rental store. - Back to top - Sweeping Sand Scatter dry concrete sand over the entire area and sweep it into the small cracks between the bricks. The sand holds the bricks tightly into place creating "interlock." This... See #6.
Crown Polymers -- Flooring Solutions
CrownWeld GF Product No. 108 Two-Component, 100% Solids, Ultra Low Viscosity, Modified Epoxy use for gravity filling cracks on moist or dry concrete surfaces down to 10°C (330°F). Product Data Sheet * Specifications and MSDS are available by contacting Crown Polymers Request Specifications Request MSDS Product Search... See #7.
BMI Products: Special: Concrete Mix BMI 908
Keep concrete damp for a minimum of two (2) days. Do not spray with water before concrete has set. Specifications Tested according to C-387 packaged dry concrete. Test Results: Compressive Strength 7 Days 28 Days Slump: 4" 4425 5078 4464 4966 4363 4804 * These are laboratory tests according to ASTM C-387. See #8.
| 
