BonTool.com-Filter Masks
...emplastar, llana mecanica, lumber crayons, lute rake, mag float, magnesium bull float, magnesium channel float, magnesium darby, magnesium float, magnesium hawks, magnesium screed, magnesium straightedge, magnetic hammer, maletines de herramientas, margin trowel, martillo, mash hammer, mason bag, mason tools, masonry chisel, masonry corner poles, masonry grout bags, masonry... See #2.
Tin Ceilings by The Tinman: Chelsea Decorative Metal Company: Tin Ceilings, Pressed Tin, Tin...
...coat of paint, we caulked all exposed edges, including where the tin abut the countertop, with a paintable latex caulk and then painted over it. Completed Example 1. Using a long straightedge and a felt-tip pen, measure and mark the height and length of the pieces and any cutouts for electrical boxes, etc. 2. Cut the sheets to size using tin snips. See #3.
Pinecrest, Inc. - Doors
The term warp shall include bow, cup and twist. In measuring the amount of warp present in a door, the following method must be used. Bow, cup and twist are measured by placing a straightedge, taut wire or string on the suspected concave face of the door at any angle (i.e., horizontally, vertically, diagonally). The measurement of bow, cup and... See #4.
Nitterhouse Masonry Products - Paving Stones - Interlocking Pavers - Installation Instructions
Step 9: Sweep Off Excess Sand Sweep off excess sand when the job is complete. The final surface elevations shall not deviate more than 3/8 in. (10 mm) under a 10 ft. (3 m) long straightedge. The surface elevation of pavers shall be 1/8 in. to 1/4 in. (3mm to 6mm) above adjacent drainage inlets, concrete collars, or channels. Step 10: Sealing... See #5.
DEPENDABLE GSL
Lightly work the transition points between pours and material over or under desired depth with a D-2 screed or spreader set to the desired depth or lightweight float or straightedge. Material should remain highly flowable and can be walked in for over 45 minutes at normal temperatures. Any imperfection can be smoothed by surface troweling... See #6.
ABC Industries - Mine & Tunnel Ventilation Products, Industrial
Ventilation Ducting...
2. Put a pen/pencil point on the Tubing Diameter scale at that diameter. (Use this as a "pivot point" in the next step.) 3. Locate your required Air Volume. Put a straightedge against the pivot point and rotate the straightedge until it crosses the Air Volume scale at your desired air volume in 1, 000’s of CFM (or equivalent m3/s). See #7.
Glass cutter and glass cutting information
Glass is so sharp that you can cut yourself without even feeling the initial contact. Make sure you do your glass repair work safely. Glass cutting begins with a straightedge or a tee square to guide your glass cutter. At the starting poin for the cut spray a little WD-40 or silicone lubricant on the glass to keep the glass... See #8.
|
